Plugs, Connectors and Receptacles

Key Features and Benefits of This Cord Clamp

The clamp provides strain relief on locking cord connectors, which reduces wear on the cord where it enters the connector body and helps prevent accidental disconnection under tension. Supporting both 20A and 30A locking three-wire ratings means one clamp part covers two common connector amperages.

Where to Use the CLAMP-GY2 Cord Clamp

This clamp is meant for use with 20A or 30A locking three-wire cord connectors on portable power cords, extension cords, and equipment feeds where the cord needs strain relief at the connector. It should only be paired with connectors rated for these exact amperages and wire counts.

Installation and Compatibility Checks

Confirm the mating connector is rated for 20A or 30A with a locking three-wire configuration before installing this clamp, since it is built to that specific connector family. The gray finish is intended to match Leviton's locking connector line rather than standard duplex devices.

Additional Buying Context

This clamp is a low-cost replacement or spare part for anyone maintaining a fleet of 20A/30A locking cord sets, letting a damaged strain relief be swapped out without replacing the entire connector. Keeping a few on hand is useful for shops that build or repair their own power cords.